Vd-tgm0001.rar Apr 2026

If there are visible seams between parts, use a small amount of or UV resin . Once dry, sand it flush with the surface for a seamless look.

: Start by connecting the largest central pieces. VD-TGM0001.rar

: This is the standard for resin kits.

To put this piece together effectively, follow these general assembly steps for this type of kit: 1. Preparation and Cleaning If there are visible seams between parts, use

: For heavy parts (like a large cape or an outstretched arm), drill a small hole in both pieces and insert a trimmed paperclip or brass wire to act as a structural "skeleton" before gluing. 5. Gap Filling : This is the standard for resin kits

: Use fine-grit sandpaper (400 to 1000 grit) to remove support marks or "seam lines" where the mold halves met. 2. Test Fitting (Dry Fit)