New Robin's.cfg -

A ".cfg" file for a (specifically the MKS Robin series) is typically a configuration file used for 3D printer firmware like Klipper or Marlin .

klipper/config/generic-mks-robin-nano-v3.cfg at master - GitHub

: STM32F103 (check your board for Nano vs. E3) Bootloader offset : 28KiB bootloader Communication interface : Serial (on USART3 PB11/PB10) 2. Essential Config Content new robin's.cfg

Before writing the config, your firmware must be compiled with these specific settings in make menuconfig : : STM32

For more specific configurations based on your model (like the or V3 ), you can find official templates on the Klipper GitHub Repository . Essential Config Content Before writing the config, your

: Copy Robin_e3.bin to a FAT32-formatted SD card, insert it into the printer, and reboot.

./scripts/update_mks_robin.py out/klipper.bin out/Robin_e3.bin . : Use the conversion script provided by Klipper

: Use the conversion script provided by Klipper to make the file readable by the board: