This device is a digital delay controller used for electrical triggering.
: Always refer to specific PDF guides like the Thermatel TD1/TD2 Manual for wiring and safety protocols.
: Adjust parameters like Trigger , OFF , and Delay to dictate when the circuit closes or opens. For Redbird TD2 Flight Simulators Go to product viewer dialog for this item. Redbird TD2 4.1 How to use the Triggerbot TD2
: Hold the SET button for about 2 seconds to enter mode selection.
💡 : Always power down your device before changing physical toggle switches or internal jumpers to avoid electrical shorts. This device is a digital delay controller used
To use the , you generally need to configure its operational mode and parameters using the on-board interface or a software-linked controller. Depending on whether you are referring to a cycle timer or a flight simulator setup, the steps vary significantly. For the ZK-KTD2 Trigger Cycle Timer Go to product viewer dialog for this item.
: If using the TD I-Series for eye-gaze tracking, enable Overlays Mode in the settings menu. For Redbird TD2 Flight Simulators Go to product
: Press SET briefly to confirm the chosen mode and begin adjusting time parameters.